External scanners include those connecting by Bluetooth, serial cable or snap-on module. This feature configures DataWedge to select an external scanner as the default scanning device immediately upon connection and revert to a built-in scanner when the external scanner is disconnected. For device-specific support notes, please refer to the Integrator Guide that accompanied the unit. Important: Support for decode parameters can vary depending on the scanning device selected. The scanner connects via USB port and cable.Scanners must be configured using SSI over USB CDC.The DS3608 and LI3608 scanners are supported only on VC80 devices running Android.LI3608 Ultra-Rugged USB SSI Laser Scanner.Note: The Zebra computing device wakes from suspend mode when pressing the scan trigger of any supported scanner.ĭataWedge supports the following Zebra USB SSI scanners: Keep Enabled on Suspend - This mode is supported on Bluetooth and pluggable scanners, and might result in faster battery drain than would otherwise be expected while in suspend mode.If the RS507 does not reconnect after the swap, DataWedge reverts to the current default scanner. Auto-selection and Battery Swap - If Scanner selection is set to Auto and an RS507 was enabled prior to a battery swap, DataWedge continues working with that RS507 scanner upon reconnection after a battery is swapped.To re-enable a Bluetooth scanner, connect the scanner and select it in the Profile or re-choose the "Auto" selection option. DataWedge does not automatically reconnect to a Bluetooth scanner if that scanner is connected while DataWedge is using a different auto-selected scanner.However, to configure decoders, reader parameters and other scanner settings, a Bluetooth scanner must be connected. After initial configuration, a Bluetooth scanner can be enabled and disabled in the Profile, even if it is disconnected from the device.To initially configure the RS507 in a Profile, the scanner must be paired and connected.When 2D Imager is selected, scanning is performed using the installed Scan or Scan/MSR module.ĭataWedge supports the following Zebra Bluetooth scanners:īluetooth scanners are supported according to the following rules:.When the camera is selected, scanning is performed with the rear-facing camera.If no Scan Module is installed, the camera is selected.If a Zebra Scan Module or Scan/MSR Module is installed, the 2D imager is selected.The "Auto" option automatically determines the best scanning device from the list of available devices based on the rules below. The list of available scanners is based on devices present in (or connected to) the unit being configured. ![]() ![]() The parameters of this feature can be configured using the Set Config API.įor Barcode Input, the Scanner selection panel determines which scanning device will be used for data capture. ![]() Note: When SimulScan is used, DataWedge concatenates all captured text into a single string, and performs processing on the concatenated string. ![]() The raw barcode data that's acquired is processed or formatted as using the Basic and Advanced Data Formatting Processing options that are found near the Output options. DataWedge supports lasers, imagers and internal cameras.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |